Volume 2 • Issue 1 • 2011
Articles
Experimental and numerical investigation into effect of elevated temperature on fretting fatigue behavior
- R. Hojjati Talemi
- M. Soori
- M. Abdel Wahab
- Patrick De Baets
Volume 2 • Issue 1 • 2011 • 2-11
Dry sliding friction and wear response of WC-Co hardmetal pairs in linearly reciprocating and rotating contact
- Yeczain Perez Delgado
- Koen Bonny
- Patrick De Baets
- Patric Daniel Neis
- Vanessa Rodriguez Fereira
- O. Malek
- J. Vleugels
- B. Lauwers
Volume 2 • Issue 1 • 2011 • 12-18
Characterization and modeling of friction and wear: an overview
- F. Al-Bender
- K. De Moerlooze
Volume 2 • Issue 1 • 2011 • 19-28
Tribological behavior of composite-steel on rolling/sliding contacts for various loads
- M. Ando
- Jacob Sukumaran
Volume 2 • Issue 1 • 2011 • 29-34
Height-independent topographic parameters of worn surfaces
- I. Barányi
- Á. Czifra
- Gabor Kalácska
Volume 2 • Issue 1 • 2011 • 35-40
Review and classification of fretting fatigue test rigs
- Jan De Pauw
- Patrick De Baets
- Wim De Waele
Volume 2 • Issue 1 • 2011 • 41-52
Degradation of carbon reinforced epoxy composites under sliding in ambient air
- H. Dhieb
- J.G. Buijnsters
- J.P. Celis
Volume 2 • Issue 1 • 2011 • 53-58
Turning specialities of ZrO2 ceramics
- G. Fledrich
- I. Pálinkás
- R. Keresztes
- L. Zsidai
- K. Petróczki
Volume 2 • Issue 1 • 2011 • 59-65
Improved handling characteristics of off-road vehicles by applying active control of steering wheel torque
- J. Kis
- L. Jánosi
Volume 2 • Issue 1 • 2011 • 66-74
Development environment for haptic feedback device on mobile agricultural equipment
- L. Jánosi
- J. Kis
Volume 2 • Issue 1 • 2011 • 75-81
Abrasive wear of different hot-dip galvanized multilayers
- L. Szabadi
- G. Kalácska
- L. Pék
- I. Pálinkás
Volume 2 • Issue 1 • 2011 • 82-91
Investigation of friction hysteresis using a laboratory-scale tribometer
- Patric Daniel Neis
- Patrick De Baets
- Yeczain Perez Delgado
- N.F. Ferreira
Volume 2 • Issue 1 • 2011 • 92-98
Developing small-aircraft service and re-construction of landing-gear leg support
- R. Lefánti
- Gabor Kalácska
- I. Oldal
- K. Petróczki
Volume 2 • Issue 1 • 2011 • 99-105
Machinability of engineering polymers
- Robert Keresztes
- Gabor Kalácska
- L. Zsidai
- Z. Dobrocsi
Volume 2 • Issue 1 • 2011 • 106-114
Roughness measurement problems in tribological testing
- Vanessa Rodriguez Fereira
- Jacob Sukumaran
- Matyas Ando
- Patrick De Baets
Volume 2 • Issue 1 • 2011 • 115-121
Effect of velocity on roll/slip for low and high load conditions in polymer composite
- Jacob Sukumaran
- Matyas Ando
- Vanessa Rodriguez Fereira
- Patrick De Baets
Volume 2 • Issue 1 • 2011 • 122-127
The symmetrical behaviour of carbon nanotubes junctions
- T.I. Pataki
- Z. Szakál
Volume 2 • Issue 1 • 2011 • 128-133
Comparing strength properties of natural and synthetic rubber mixtures
- T. Renner
- L. Pék
Volume 2 • Issue 1 • 2011 • 134-141